Load Trimmer
|
|
Grass Gator 8010 Load n’ Cut Replacement String Trimmer Head $9.61 Replacement trimmer head will fit 99% of all gas trimmers including: Ryobi, John Deere, Echo, Stihl, Homelite, Bolens, Weed Eater, Craftsman, Toro, Cub Cadet, Troy Bilt, and Poulan. Easy to install, no tools required. Uses easy to install .130 precut repl… |
|
|
Grass Gator 8020 Load n’ Cut Precut Replacement Line $3.28 Replacement pre cut line for Grass Gator model No. 8010 load and cut gas trimmer head. .130″ diameter…. |
|
|
Speed feed 375 quick load trimmer line head for Echo $29.99 |
|
|
Speed feed 375 quick load trimmer line head for Red Max $29.99 |
|
|
WEED WARRIOR PUSH LOAD ELECTRIC TRIMMER HEAD FREE SHIP $15.99 |
|
|
quick load trimmer head part 4 Shindaiwa 78890-11000 $32.99 |
|
|
LOAD N CUT TRIMMER HEAD, 705158 $18.99 |
|
|
Tanaka 32307 No Brainer Quick Load Trimmer Cutting Head $19.99 |
|
|
Tanaka no brainer quick load trimmer head curved shaft $19.99 |
|
|
RAPID LOAD TRIMMER HEAD ECHO x480000020 FITS MANY $32.99 |
|
|
Shindaiwa E-Z Load Trimmer Head P/N 80734 $28.95 |
|
|
Speed feed 375 quick load trimmer line head for Echo $29.99 |
|
|
WEED WARRIOR ELECTRIC PUSH N LOAD TRIMMER HEAD 14864 $13.99 |
|
|
1 EACH LOAD N CUT TRIMMER HEAD # 8010 NEW $19.99 |
|
|
NEW C M D LOAD N CUT TRIMMER HEAD 8010 $19.99 |
|
|
RAPID LOAD 4 STRING TRIMMER HEAD NEW IN PACKAGE $19.99 |
|
|
“The Puck” Easy Load Trimmer Head. ECHO, STHIL, Ect…! $31.80 |
|
|
shindaiwa 22T & F EZ Load trimmer head SPOOL #10103 $5.89 |
|
|
shindaiwa 22T & F EZ Load trimmer head SPOOL late $5.89 |
|
|
Tanaka no brainer quick load trimmer head curved shaft $19.99 |
What would be the best approach to installing an exterior beam to reinforce a load bearing opening?
I am taking out a good portion of my kitchen wall (18 feet) to allow flow into my living room. This is a load bearing wall, it was once the exterior wall, I will have a supporting column in the center of this opening. My ceiling height is low in my kitchen so I have to watch how wide of a beam I use at the pass through. I can’t put reinforcing beams in the attic because of the cluttered structure configuration, so I am adding a support beam on the living room side over the opening. This beam will be attached directly to the vertical roof supports and to the new reinforcing beams on each side of the column. This beam will be exposed and trimmed out to match the decor. What would be the best material for this beam and are there any new products out that are dedicated to this application?
You really need to get an engineer to look at your project & make the call on the beam, however, having said that, since this was originally an exterior wall, your beam will need to span the opening (where the wall was), not beside it.
I’m assuming that the “cluttered structure configuration” are pre-built trusses.
The truss you remove the wall from is going to have to be supported.
Good luck…